Cable Passthrough Adaptor

If you would like a size that is not listed, please reach out to us on the Discord.

A backpack mod we’ve created allow cables to pass through your backpack wall.

A hole in your backpack wall is required for the proper installation of the product (we found a craft knife was the best way of getting a clean cut).

25mm Cable Passthrough Option

• Inner diameter 25mm
• Thread diameter 37mm

This size will allow a full size HDMI to pass through with a few millimetres spare for clearance along with additional cables.

20mm Cable Passthrough Option

• Inner diameter 20mm
• Thread diameter 30mm

This size will allow a full size USB Type A to pass through with a few millimetres spare for clearance along with additional cables.

Installation Tips

Offer the bolt thread up to your backpack wall, mark the edges with a pen/pencil. Make a crossed incision within the marked circle, this should be sufficient to then push/twist the bolt through the wall of the backpack.

Information

Please note that the product is not watertight, it is recommended that you use a waterproof adhesive around the edge of the outer shell of the front thread section to glue it to the outside of your backpack.

BAG AND CABLES USED IN PHOTOS ARE FOR REFERENCE ONLY – NOT INCLUDED