Description
A backpack mod we’ve created to allow airflow within your backpack, whether or not you choose to fix this within your backpack wall or place freely inside.
What’s included
- x1 Double Fan Mod to hold two 40mm x 10mm fans
- x4 Cross Thread M3 Bolts with brass inserts preinstalled
- x2 4mm backpack wall spacer
- x2 1mm backpack wall spacer
- x2 40mm x 10mm USB fans (Optional)
- x1 USB Type A, Y Splitter (Optional)
Measurements
- Total size when assembled: 128mm Length x 64mm Width x 26mm Depth Approx.
- 10mm backpack wall clearance space with x2 4mm spacers and x2 1mm outer spacer to cater for different wall thickness
- Fits backpacks with up to 10mm wall thickness
Installation Recommendation/Information
- Place or glue the 1mm spacer to the outside of your backpack at the desired location
- Cut around the inside of the spacer to form a hole in the backpack (craft knife recommended)
- Use the required spacers provided depending on your backpack wall thickness over the rear section
- Offer the rear section through the inside of the backpack wall and then screw on the front section to the outside
Video example (Older version, but the same principle): https://www.instagram.com/reel/C1CnqaeIFna/
Please note that the product is not watertight, it is recommended that you use a waterproof adhesive around the 1mm spacer which is placed on outside of the bag.
The product is however water resistant when properly affixed to your backpack with waterproof adhesive, the vents will cause water to run off at the desired angle selected and mounting orientation.
Damage caused to the product by overtightening is not covered under our replacement policy.
BAGS USED IN PHOTOS IS FOR REFERENCE ONLY – NOT INCLUDED
